Brand:

pro clima TESCON VANA

All-round tape with fleece carrier, for indoor and outdoor use

Product benefits

The text on this page was automatically translated. Minor translation errors are possible. In case of doubt, the original versions (Dutch and French) are correct.

100 years of adhesive strength – independently tested and approved
For indoor and outdoor use - reliably airtight and driving rainproof
Waterproof adhesion – SOLID adhesive
Plasterable

Installer benefits

Multi-purpose - adheres to most smooth and flat surfaces (films, wood (derivatives), mineral surfaces, metal…)
Various widths (6cm - 7.5cm - 10cm - 15cm - 20cm - 30cm) - for optimal use
Lifetime assurance – for contractor, builder, architect…
Winter application: from -10°C
Easily processable

Applications

Multifunctional

Airtight and/or driving rainproof taping of:

Films with each other (vapor barriers, underlay and wall protection films)
Films with smooth adjoining building parts: wood (derivatives), mineral surfaces, metal, plastic etc…
Joints between airtight panels (OSB, etc…) in timber frame construction
Wood fiber boards, (ridge) gutters, in combination with TESCON SPRIMER or TESCON PRIMER RP

On metal beams to prevent rust penetration and as a carrier for plasterwork

Project types

Renovation,

New construction,

Prefabricated

Applications

Airtightness,

Rain, water, and windproof connections

Construction methods

Masonry (or concrete),

Timber construction (timber frame, CLT,...),

Steel frame construction

Construction elements

Product details

Installation steps

1. Preparation

Subsurfaces must have sufficient stability and be dry, level and free of dust, silicone and grease.

Brush off all subsurfaces; if necessary, clean with a vacuum cleaner and wipe down. Carry out an adhesion test, if necessary.

2. Taping membrane overlaps

Centre TESCON VANA on the membrane overlap and gradually stick it in place, ensuring that there are no folds or tension.

Rub the tape firmly to secure the adhesive bond.

PRESSFIX is easy to use and protects your hands.

Ensure that there is sufficient resistance pressure.

6. Sealing to smooth, non-mineral subsurfaces …

3. Joints to smooth, non-mineral subsurfaces

… (e.g. knee walls made of wood-based panels) should also be implemented using TESCON VANA.

Centre the tape and gradually stick it in place, ensuring that there are no folds or tension.

4. Taping membranes on the outside

Reliable adhesion in outdoor areas too thanks to water-resistant SOLID adhesive.

Centre the tape and stick in place, ensuring that there are no folds. Rub using the PRESSFIX tool to secure the adhesive bond. Ensure that there is sufficient resistance pressure.

5. Sealing around pipes and cables

Place a KAFLEX or ROFLEX sealing grommet over the cable or pipe and stick the grommet to the membrane.

The cable grommets are self-adhesive.

Tape the pipe grommets to the membrane using TESCON VANA.

6. Apply primer to wood-fibre underlay panels

Apply TESCON PRIMER system primer.

Full ventilation is not necessary.

The tape can be positioned centrally over the butt joint and applied onto the wet primer, and then gradually stuck in place ensuring that there are no folds or creases.

Adhesive joints to protect against rain should be started at the bottom and should overlap in an interlocking pattern.

General conditions

Taped joints must not be subjected to tensile forces. Once membranes have been taped, the weight of the insulation material must be supported by laths. Taped joints should be supported by additional laths, if necessary. Rub the adhesive tapes firmly to secure the adhesive bonds. Ensure that there is sufficient resistance pressure.

Windproof, airtight or rainproof sealing can only be achieved on vapour check or underlay/facade membranes that have been installed without folds or creases. Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary. When plastering, please observe the recommendations of the plaster manufacturer for non-absorbent subsurfaces. A bonding course may be necessary.

Reference Number	Attributes
11250	Dimensions: 7.5cm x 30m
11251	Dimensions: 15cm x 30m
13491	Dimensions: 20cm x 30m
15076	Dimensions: 10cm x 30m
1AR02070	Dimensions: 6cm x 30m
1AR03059	Dimensions: 30cm x 30m